10 April 2009

POKéDOLLS Team 6 - Surf Pikachu, Unown, Gengar

SURF PIKACHU DOLL
Height: 13 cm / 5.1 in
No. of Pages: 3
Level: Medium
Designer: POdragon / Paperbuff
Builder: Paperbuff
Download: A4 / Letter


UNOWN DOLL
Height: 2.8 cm / 1.1 in
No. of Pages: 3
Level: Medium
Designer: POdragon
Builder: Skelekitty
Download: A4 / Letter


GENGAR DOLL
Height: 13.3 cm / 5.2 in
No. of Pages: 4
Level: Medium
Designer: Brandon / POdragon
Builder: Skelekitty
Download: A4 / Letter


POKéDOLL TABLE
Height: 7.8 cm / 3 in
No. of Pages: 3
Level: Easy
Designer: Brandon
Builder: Paperbuff
Download: A4 / Letter

10 comments:

  1. Carlos Jiménez10 April, 2009 00:53

    Thaks for posting a surfing pikachu doll i like pikachu, special when it uses Volt tackle, ji ji ji...Thanks...

    ReplyDelete
  2. Helmy21 April, 2009 11:37

    simple but good

    ReplyDelete
  3. Anonymous23 June, 2010 19:17

    how do you do the back of gengar!

    ReplyDelete
  4. Jeasmin24 June, 2010 02:34

    Don't you have a 'Shellder' ?
    I can't Find this Model.
    I think It just in a picture?

    ReplyDelete
  5. PAPERPOKES24 June, 2010 02:41

    @ Jeasmin
    http://www.pokemonpapercraft.com/2009/03/pokedolls-team-3-tentacool-magikarp.html

    ReplyDelete
  6. Anonymous26 January, 2011 22:52

    Do you have a smaller pikachu? I was only able to make the smallest of the pokeball boxes since i had to use the schools cause ours isn't hooked up yet. All the small pokemon you've put up are cute, but they're too big to fit! It has to be under 4 inches! I know the unown would work, but I would prefer a skitty or, better yet, pikachu. If you could shrink it down or something, it'd be very appreciated!

    -8th grade pokemaniac!!!

    ReplyDelete
  7. Shana30 March, 2011 13:20

    Wow!love the unown
    and surf pikachu!

    ReplyDelete
  8. TheDude07 June, 2011 05:03

    @Anonymous

    If you need it smaller, use the pdf, and select the scale...the print window opens with ctrl+p, and you should be able to select a scale in percent. If you go below 100%, it should come out nicely without a hitch. A model normally 20cm in height printed at 50% will be 10cm after building

    ReplyDelete
  9. Fernando10 July, 2012 21:29

    I know you guys are busy and I love all the work you all have done, but I was wondering if you knew anyone else who had the complete unown collection?

    ReplyDelete
  10. Anonymous04 March, 2015 13:54

    can you please do a skitty or bulbasaur card?=3
    im your biggest papercraft fan!=D
    by:meli504(scratch user)

    ReplyDelete