21 March 2011


374 / BELDUM - Pokémon Papercraft
Name: Beldum
Type: Steel/Psychic
Species: Iron Ball Pokémon
Height: 0.6 m (2′00″)
Weight: 95.2 kg (209.9 lbs.)
Interesting Facts: Beldum is a robotic lifeform that has a long body with a set of claws sticking out of its rear end. It has one large red eye in the center of its nearly-round head, which is set into a ball-and-socket joint at its front end. It has a short crest above its head, projecting from its body. Even though Beldum and its evolved forms are mechanical creatures, they still have emotions, the need to eat and a way of reproducing. Beldum has been said to be related to Magnemite due to the fact that both of them are partially Steel-type that create electromagnetic waves to float in the air, and probably due to the fact that they evolve in a similar fashion, it takes two Beldum to evolve into a Metang and two Metang to evolve into a Metagross.

Height: 9.9 cm/ 3.9 in
Width: 4.0 cm/ 1.6 in
Depth: 4.0 cm/ 1.6 in
Pages: 1
Pieces: 19
Level: Easy-Medium
Designer: Brandon
Photo: Brandon
NOTES: Build from the head down, gluing the head to the main piece and closing the main piece at the bottom. Attach the base to the body to finish. Before closing the base however, attach the claws so that pressure can be exerted on the inside.
It is also in scale with Metang, but neither are the exact scale as Metagross. Keep in mind it is extremely small; it's slightly simpler than v1, but the head can be a bit tougher because of the size.

Download: A4 / Letter

Beldum v1


Anonymous said...

Is this one smaller then the old version?

Brandon said...

Yes, by about 5 cm.

Sarah :D said...

is there a way to download the v1 of the models uve made? or is the first version noit available anymore?

Brandon said...

Yup, of course. If you just search for Beldum in the search bar on the side, the first version will come up as well. Same goes for Pikachu, Dragonair, Phanpy, and anything else that was remade.

Anonymous said...

When i open the.pdo file of beldum in pepakura designer (v3.0.8)I get an error: Failed to start up Pepakura Viewer.

Could you upload it again plz..

Brandon said...

That's because you have to use Viewer, not Designer. It's on the same download page as Designer.

Unknown said...

Would you please make this thing bigger? This thing is cool, but if you made this bigger, that would be great.